Access-Controller Restrict Location; Service-Sensor; Service-Sensor Poll - HP MSM3xx Reference Manual

CLI commands

access-controller restrict location

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
access-controller restrict location (gateway | mac <mac address>)
Identifies the access controller the AP will communicate with.
Parameters
gateway
mac
<mac address>

service-sensor

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
service-sensor
Enables the service sensor. The service sensor polls a target device at present intervals. If the
device does not respond, the radio is shut off.
no service-sensor
Disables the service sensor.
service-sensor
Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
service-sensor (gateway | address<ip address>)
Sets the target device the service sensor will poll. This can be the default gateway or a specific IP
address.
no service-sensor
Disables the service sensor.
Parameters
gateway
address
<ip address>

service-sensor poll

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
service-sensor poll <seconds>
Sets the poll frequency.
Parameters
<seconds>
2-32
Use the default gateway as the service controller.
Use the specified MAC address as the gateway.
MAC address. Specify 6 pairs of hexadecimal numbers separated by
colons, with the values a to f in lowercase. For example: 00:00:00:0a:0f:01
The service sensor will poll the default gateway.
The service sensor will poll another device.
IP address of the other device. For example: 192.168.10.10
Poll frequency. Range: 1 - 3600 seconds.