Table of Contents
Advertisement
line containing at least 91 octane. Do
not top-off tank, leave at least 1 inch
of open space at top of tank.
9.
Replace Fuel Cap. Hand tighten by
turning clockwise.
10.
Clean up any spilled gas with a dry
cloth.
Fire Hazard! Do not fill
gas tank when the engine is
running, or near a pilot light
or open flame or when hot.
Do not smoke. Do not operate
if gasoline has been spilled.
clean spilled gasoline before
starting the engine.
Starting the engine
1.
During this procedure, it may be help-
ful to refer to the photos of the Engine
Controls on page 10.
2.
Push the Gas Valve to the
open (right) position.
3.
Close the Choke by pulling
it to the left.
4.
Note: If the Engine is already hot, it is
not necessary to close the Choke.
5.
Push the
Throttle
Lever to the
slow (right)
position , then move it back slightly.
6.
Turn the Engine Switch to the On
position.
7.
Gently pull the Pull Cord Handle until
it engages. Then pull it hard and all
SKU 65322 or 65323 For technical questions, please call 1-800-444-3353.
the way out. Slowly guide the Pull
Cord back into the starter. The En-
gine should start. Try again if it does
not start. Refer to the Troubleshoot-
ing section if problems persist. Let
the engine run for five minutes to
warm up.
8.
Push the Choke to the
right
9.
Push the Throttle Lever to
the fast position (left).
Stopping the engine
1.
Push the
Throttle
Lever to the
slow (right) position.
2.
Turn the Engine Switch to the Off
position.
3.
Push the Gas Valve to the closed
(left) position.
Page 12
Advertisement
Table of Contents
Troubleshooting
