Water Pump Maintenance; Engine Maintenance - Pacific hydrostar 66585 Assembly And Operation Instructions Manual

6. Once the Engine starts, slowly move
the Engine Choke to its "RUn" position.
Then adjust the Engine Throttle to the
speed (RPM) you desire.
7. Once the Engine starts, the Water Pump
will run continuously until the Engine is
turned off. To turn off the Engine, press
the Engine Kill Switch (40).
8. Allow the Water Pump and its Engine to
completely cool before moving or storing
the Pump.
inSPECTiOn, MAinTEnAnCE, And
CLEAninG
FROM ACCidEnTAL STARTinG:
Turn the Power Switch of the
equipment to its "OFF" position,
wait for the engine to cool, and
disconnect the spark plug wire(s)
before assembling or making any
adjustments to the equipment.
before each use, inspect the general
condition of the Water Pump and
its Engine. Check for loose parts,
misalignment or binding of moving parts,
damaged parts, loose hose connections,
and any other condition that may affect
the safe operation of the Water Pump. If
abnormal noise or vibration occurs, have
the problem corrected before further use.
do not use damaged equipment.

EnGinE MAinTEnAnCE

note: This maintenance schedule is
intended solely as a general guide. If
performance decreases or if equipment
operates unusually, check systems
immediately. The maintenance needs
of each piece of equipment will differ
depending on factors such as duty cycle,
SKU 66585
TO PREVEnT
SERiOUS injURy
For technical questions, please call 1-800-444-3353.
temperature, air quality, fuel quality, and
other factors.
note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular operation
of the engine and equipment.
After initial 20 Operation Hour Period:
a. Change engine oil.
Every 25 Operation Hours Thereafter:
a. Clean/replace air filter element.
b. Replace spark plug.
Every 50 Operation Hours:
a. Change engine oil.
b. Replace fuel filter (if equipped).
Every 100 Operation Hours:
a. Replace air filter element.
note: All maintenance procedures scheduled
for 25, 50, and 100 operation hours
should be performed at least yearly.
Every 300 Operation Hours:
a. Clean fuel tank and carburetor.
b. Clean carbon build-up from combustion
chamber.

WATER PUMP MAinTEnAnCE

1. Before each use, check the Intake Filter
for accumulated debris, rocks, and other
objects that may clog the Filter.
2. Before each use, check to make sure
there is water in the Water Pump
Housing. If there is not enough water,
unscrew the Priming Cap and add water
to the Pump Housing.
3. If the Water Pump is not in use due to
dry conditions, etc., prime the Water
Page 10