Table of Contents
Advertisement
2
Quick Start Guide
If you are familiar with bar code verifiers, this section will get you up and running
in a few minutes. We assume the factory defaults are in effect.
1. Install the batteries
•
Slide off battery cover on the bottom of unit.
•
Insert four batteries into compartment, matching "+" on battery ends
with "+" in case.
•
Slide battery cover back in place.
2. Charge the batteries
•
Plug AC charger into port on back of unit.
•
Plug charger into a VAC wall outlet.
•
Charge completely discharged batteries at least 12 hours; charge low
charge batteries less time.
•
After charging, remove AC charger from unit.
3. Turn on the verifier
•
Press POWER. Unit emits four quick beeps.
If unit displays:
•
RECALIBRATE, calibrate unit. Go to
•
LOW BATTERY!, charge batteries. Go to
•
NO PRINTER ATTACHED... records may be stored in buffer. Use
arrow keys to select an option. Either continue to scan using current
AutoPrint/Store setting, clear (delete) records, or change AutoPrint/
Store setting to
•
PRINT BUFFER... records are stored in buffer. Use arrow keys to
select an option. Either continue to scan and leave records in buffer,
print records, or clear (delete) records. Go to
•
SCAN, go to
•
QUICK-CHECK Opening Menu, go to
4. Calibrate the unit
•
Scan reflectance page if you're using either a pen or mouse wand.
Three beeps (one long, two short) sound after a good scan.
•
Continue to scan page for ten good scans.
5. Scan the bar code symbol
•
The scan grade display appears. (Extended Accuracy setting default
is off).
•
To obtain final symbol grade, scan symbol nine more times (# Scan/
Symbol setting default is 10).
6. Review the scan results
Quick Check® 600/800 Series User's Guide
(not store data). Go to
Off
step 5.
step 4.
step 2.
step 5.
step 5.
step 5.
Chapter 1
Chapter 1
Chapter 1
Chapter 5
Chapter 1
Chapter 3
Chapter 4
2 - 1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
