The Receiver Unit - Omega Comfort Start Operating & Installation Instructions Manual

Once the Comfort Start is in Valet Mode, an attempt to remote start will in-
stead be acknowledged by 1 long and 3 short parking light flashes, but no start-
ing attempt. If the horn is connected, it will sound and then chirp 3 times.
- To turn off Valet Mode, simply press the Valet Switch.

The Receiver Unit

An important part of the Comfort Start system is its Receiver Unit.
As its name implies, the Receiver Unit contains the radio receiver
needed for the system to operate from the hand-held transmitter.
The Receiver Unit also contains the Valet Switch and Status Light;
the operations of which are explained throughout this guide.
The Receiver Unit is designed for
mounting directly on the vehicles' win-
dow glass, which also gives the sys-
tem its best operating range. Should
this not be possible or desired, the Re-
ceiver Unit may be mounted in a hid-
den location, and provisions are made
for optional separately-mountable Va-
let Switch and Status Light.
Blue
•
Status Light
is inside the clear
case, and shows
certain operations
•
Valet Switch
used for Valet Mode
and in programming
8
switch wire, provided the circuit operates with 1/2 Amp of current or less. The horn wire
is typically found around
Optional Relay Wiring Diagram
the steering column; the
correct wire will show
Positive 12 Volts norm-
ally, and no voltage when
Constant
the horn is being sounded.
(+) 12 Volt
If the horn circuit requires
more than 500mA, use
Connect to (+) or
this diagram to config-
(-) as needed to
ure an optional relay.
operate the horn.
Wiring - 2 Wire (3 Cavity) Connector
22 Gauge Green Wire:
Connection If Desired
The Green wire supplies a negative pulse for lock-
ing the vehicle's doors.
22 Gauge Blue Wire:
Connection If Desired
The Blue wire supplies a negative pulse for locking
the vehicle's doors. Programmable feature
double unlock pulse.
To vehicle's
horn wire.
30
86 87a 85
87
Brown wire
from module.
500mA ( - ) Lock Output
500mA ( - ) Unlock Output
# 3 changes the single unlock pulse to be a
33