Table of Contents
Advertisement
LIMITED LIFETIME WARRANTY
Products manufactured and sold by OMEGA RESEARCH & DEVELOPMENT, INC. (the Company),
are warranted to be free from defects in materials and workmanship under normal use. If a product
sold by the Company proves to be defective, the Company will repair or replace it free of charge
within the first year and thereafter all parts to be repaired will be free with only a nominal charge for
Omega Research and Development, Inc.'s labor and return shipping, to the original owner during
the lifetime of the car in which it was originally installed.
All products for warranty repair must be sent postage prepaid to Omega Research &
Development, Inc., P.O. Box 508, Douglasville, Georgia 30133, with bill of sale or other dated proof
of purchase. This warranty is nontransferable and does not apply to any product damaged by
accident, physical or electrical misuse or abuse, improper installation, alteration, any use contrary
to its intended function, unauthorized service, fire, flood, lightning, or other acts of God.
This warranty limits the Company's liability to the repair or replacement of the product. The
Company shall not be responsible for removal and/or reinstallation charges, damage to or theft of
the vehicle or its contents, or any incidental or consequential damages caused by any failure or
alleged failure of the product to function properly. Under No Circumstances Should This Warranty,
Or The Product Covered By It, Be Construed As A Guarantee Or Insurance Policy Against Loss.
The Company neither assumes nor authorizes any person or organization to make any Warranties
or assume any liability in connection with the sale, installation, or use of this product.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and, (2) This device must accept any
interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio TV interference caused by unauthorized modifica-
tions to this equipment. Such modifications could void the user's authority to operate the equipment.
10/03 MA_Comfort Start
OPERATING & INSTALLATION
INSTRUCTIONS
Comfort Start
DELUXE KEYLESS ENTRY & REMOTE STARTER
FOR AUTOMATIC TRANSMISSION VEHICLES ONLY
COPYRIGHT: OMEGA RESEARCH & DEVELOPMENT 2003
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Omega Comfort Start
Summary of Contents for Omega Comfort Start
- Page 1 Omega Research and Development, Inc.'s labor and return shipping, to the original owner during the lifetime of the car in which it was originally installed.
-
Page 2: Table Of Contents
Reversing Polarity System Using External Relays Contents Operation Guide Control Blue Wire Module Introduction & Safety Considerations ................3 Basic Transmitter Functions Overview ................ 4 Remote Locking & Unlocking the Doors ..............5 Green Remote Starting the Engine ..................6-8 Wire The Receiver Unit ...................... -
Page 3: Introduction & Safety Considerations
This means that both the lock and unlock wires must be "opened", or cut, to make the proper connections. vehicle to warm up in winter and cool down in summer. The Comfort Start can also be optionally configured to remotely open your vehicle’s trunk. -
Page 4: Basic Transmitter Functions Overview
The Comfort Start includes with two 5-button remote transmitters.* Please fa- Red Connector miliarize yourself with the control buttons, as shown here, and operations of the Control transmitters and Comfort Start system which are explained in the following pages. Blue Wire Module •... -
Page 5: Remote Locking & Unlocking The Doors
3 Wire Positive Pulse Systems Locking & Unlocking the Doors This doorlock system is similar to the 3 wire negative pulse system except the doorlock To Lock the Vehicle's Doors: Press & Release the left transmitter LOCK switches send +12 Volt pulses to operate the doorlock relays/control unit. button Examine the wires on the back of the doorlock switch: THE PARKING... -
Page 6: Remote Starting The Engine
- The engine will start, run, and the starter will be disengaged. Switch Vehicle's Doorlock - The parking lights will turn back on and remain on while the Comfort Start is Doorlock Relay Control Unit controlling the engine. The status light will continue to flash slowly. - Page 7 "On" position. Do not turn the key to the "Start" position. power doorlock system. The vehicle must have existing power doorlocks; or, if it does not, power doorlocks may be added to the vehicle in the form of installing an Omega Deactivation actuator to each of the doors, along with a doorlock interface.
-
Page 8: The Receiver Unit
1/2 Amp of current or less. The horn wire Once the Comfort Start is in Valet Mode, an attempt to remote start will in- is typically found around stead be acknowledged by 1 long and 3 short parking light flashes, but no start- Optional Relay Wiring Diagram the steering column;... -
Page 9: Remote Panic & Emergency Flashlight
Remote Panic & Emergency Flashlight configured as follows: Connect to 12 Volts or Negative Ground as needed (In this example To Activate Panic*: Press & Hold the left transmitter LOCK button Negative is required) for 3 seconds Control Gray Wire Release THE PARKING LIGHTS Module... -
Page 10: Remote Trunk Release
Starter Motor Car “A” Car “B” The Comfort Start transmitter can operate two dif- ferent vehicles equipped with Comfort Start sys- tems. The slide switch on the side of the transmit- 20-Gauge Gray Wire:... -
Page 11: Programmable Features
The correct wire will show no The Comfort Start has 11 programmable features, some of which are “opera- change in voltage when the dimmer is operated. Some vehicles have a parking-light relay which is triggered by a Negative signal from the headlight switch. - Page 12 The Comfort Start’s 11 programmable features are: When feature #6 is selected for “two pulse” operation, once the Comfort Start unit has started the engine, the Pink/Black wire must receive two more Negative pulses within 10 FEATURE DEFAULT OPTION seconds to stop the engine. See pages 11-13 for programmable features instructions.
- Page 13 - “Doors Lock/Unlock Upon Ignition On/Off” (feature #8), being factory-set “on”, operation. If the Pink/Black wire receives a Negative pulse, the Comfort Start unit will start the vehicle's engine, provided that all safety circuits are in the proper status. After...
-
Page 14: Programming Transmitters
The Yellow/ Light will illuminate, and the horn chirps once to indicate that the unit is ready to Green wire has a -Ground pulse whenever the Comfort Start unit has an unlock output or receive the first transmitter code. -
Page 15: Installation Instructions
WARNING DECAL to a visible area in the engine compartment! Learning the Tach Wire Sensing must be performed after all wiring connections are made, and the Comfort Start unit has been programmed for Tach Wire Sensing operation Installation Considerations: This entire booklet should be read before starting the (the unit must be programmed- see pages 11-13). -
Page 16: Installation Cautions And Warnings
Installation Cautions and Warnings Instead of using a pin switch to monitor the hood's open or shut status, an Omega AU-46 Mercury Tilt Switch may used. Connect one of the AU-46's wires to Negative Chassis Ground and connect the remaining wire to the Blue wire. -
Page 17: Main & Receiver Modules
Receiver Module. Carefully route the module’s 5-wire ribbon ( - ) Hood Input 20-Gauge Blue Wire: cable to the Comfort Start control module; plug the cable into the Black 3-pin port on the Connection Required- The Hood Safety Switch must be installed rear of the module, and plug the remaining two connectors into their respective 2-pin ports and the Blue wire must be connected. -
Page 18: Wire Main Harness
Wiring Connections - 6 Wire Main Harness more Primary Ignition wires are present in the vehicle an optional relay is needed, con- nected to this wire as shown in the diagram. (Two 12-Gauge) Red Wires: Constant +12 Volts Input 22 Gauge Red Wire: ( + ) Output For Optional Relay Coil Connection Required . -
Page 19: Wire Connector
Ignition or Starter circuits. Connect the White wire to the vehicle's Accessory Omega OEM security bypass interfaces also use this Red port. wire. This circuit supplies power to the Heat, Ventilation and Air Conditioning (HVAC) system. -
Page 20: Wiring Diagram Overview
WIRING DIAGRAM OVERVIEW Black/Yellow: Hood Pin To Coil Switch Starter Yellow/Green: Orange: (-) Output When OEM Disarm Smart Receiver OPTIONAL Activated Blue: Start Unit RELAY FOR Yellow/Red: Yellow/Green: ANTI-GRIND Adjust OEM Arm Hood Programmable Switch Output Ignition Red/Black: STATUS LIGHT PORT (page 22) Switch Green:...
Need help?
Do you have a question about the Comfort Start and is the answer not in the manual?
Questions and answers