Remote Trunk Release; Multiple Vehicle Operation - Omega Comfort Start Operating & Installation Instructions Manual

Remote Trunk Release

To Activate the Trunk Release*:
- The trunk will be released after 2 seconds. The parking lights and Status Light
will flash twice to confirm and the doors will unlock. Then the parking lights will
stay on for 30 seconds. Optionally, the horn will also chirp 2 times.
* Connection of the trunk release may require additional parts, and may not be included
in a standard installation.

Multiple Vehicle Operation

Car "A" Car "B"
The Comfort Start transmitter can operate two dif-
ferent vehicles equipped with Comfort Start sys-
tems. The slide switch on the side of the transmit-
ter is utilized for this- one car can be operated in
switch position "A" and the second car in switch
The "multi-car" switch on
position "B".
the side of the transmitter
Press & Hold the lower transmitter
TRUNK button for 2 seconds
OPERATE OPTIONAL
TRUNK RELEASE
10
Typical Anti-Grind Relay
Configuration
Connect "Switch" side of cut wire
#
to terminal 30 of the relay.
Ignition Switch
Relay
Connect "Motor" side of cut wire
Schematic:
to terminal
87a
30
Note: Connect 12-gauge
Green starter wire to the
motor side of the cut wire
20-Gauge Gray Wire:
Connection If Desired .
put which is operated by the transmitter button with the "open trunk" icon, and this output
is designed for trunk release. In most cases, an optional external relay will be needed,
30
Control
Module
87a
86
85
87
Orange Wire
# 87a of the relay.
Starter Motor
( - ) Trunk Release Output
The Gray wire has a 500mA Negative out-
31