Frigidaire Gas Range Use & Care Manual page 37

Problem Possible Causes
Oven portion of Gas regulator shut-off valve
appliance does not may have been moved to OFF
operate. Gas at installation.
cooktop burners
Incorrect oven control
operate.
setting.
Entire appliance
Power supply to appliance
does not operate. disconnected or electrical
power outage.
Service wiring is incomplete.
Range is not level. Floor is not level, weak or
unstable.
The cooktop or oven racks
are not level.
Cabinet alignment may make
range appear not level.
Cannot move
Gas line is hard-plumbed.
appliance easily.
Appliance must be
Carpet interferes with range.
accessible for
service.
Cabinets are built in too
tightly to appliance sides.
Convect fan makes
The convect fan may turn ON
noise (some models).
or OFF automatically.
Convect fan does not The convect fan start time is
start immeadiately or delayed.
turns ON and OFF
Oven door is open.
while cooking (some
models).
The convect fan may turn ON
Convect fan turns on
while preheating.
with features that
should run without a
fan (some models).
Oven control displays The probe is not fully inserted
"Prob ERR". The into the probe receptacle.
probe is not
recognized by the
If the error code persists, the
oven control.
probe may be damaged or
the probe cable has a short.
Solutions to common problems •
Solutions
Be sure gas regulator valve is set to the ON position. See
installation instructions.
Be sure the oven control was set correctly for the requested
feature. See Setting Oven Controls section and review
instructions for the desired cooking function in this manual or
see "Entire appliance does not operate" in this checklist.
Be sure appliance power cord is plugged properly to electrical
outlet. Check house circuit breaker; reset if needed. If the
electric service to the house is out, call your local electric utility
for service.
Contact your dealer, installing agent or authorized service agent
for assistance.
If floor under range is sagging or sloping, contact a carpenter to
correct the problem.
To correct, place oven rack in center of oven. Place a bubble
level centered on the oven rack. Adjust by turning leveling legs
at bottom of range until the oven rack rests level.
Be sure kitchen cabinets are square and have sufficient room for
appliance clearance.
Replace gas supply line with a flexible CSA International
approved metal appliance connector.
Provide sufficient space so appliance may be lifted over carpet.
Contact builder or installer to make appliance accessible.
This is normal. On some cooking features the convect fan may
run until the feature is done or the oven door is opened.
This is normal. The convect fan will take 6 minutes to begin
rotating after starting any convect feature.
The convect fan will turn OFF if the oven door is opened while
any convect feature is active. Close oven door.
This is normal (on some models).
Double check that the temp probe is fully inserted into probe
receptacle. Use only the probe originally supplied with range.
Remove the probe from receptacle and oven. The oven may
still be used normally without the probe. Call your authorized
service agent.
BEFORE YOU CALL
37