Frigidaire Gas Range Use & Care Manual page 22

SETTING OVEN CONTROLS
Probe (cont'd)
USDA recommended minimum internal cooking
temperatures:
Food type
Ground meat & meat mixtures
Beef, Pork, Veal, Lamb
Turkey, Chicken
Fresh beef, veal, lamb
Medium rare†
Medium
Well done
Poultry
Chicken & Turkey, whole
Poultrey Breasts, Roasts
Poultrey Thighs, Wings
Duck & Goose
Stuffing (cooked alone or in bird)
Fresh pork
Ham
Fresh (raw)
Pre-cooked (to reheat)
Eggs & egg dishes
Eggs
Egg dishes
Leftovers & Casseroles
Information courtesy the U.S. Department of Agriculture
Food Safety and Inspection Service.
† The U.S. Department of Agriculture states, "Rare
fresh beef is popular, but you should know that
cooking it to only 140°F/60°C means some food
poisoning organisms may survive." (Source: Safe
Food Book, Your Kitchen Guide, USDA Rev. June 1985.)
Visit the U.S. Department of Agriculture Food Safety and
Inspection Service website at www. fsis.usda.gov
22
Internal temp.
160°F (71°C)
165°F (74°C)
145°F (63°C)
160°F (71°C)
170°F (77°C)
165°F (74°C)
165°F (74°C)
165°F (74°C)
165°F (74°C)
165°F (74°C)
160°F (71°C)
160°F (71°C)
140°F (60°C)
Cook until yolk & white are firm.
160°F (71°C)
165°F (74°C)
Fig. 1
Choosing a setting for how the oven will operate
once the probe reaches the target temperature
Your oven is factory preset to automatically stop cooking
and start the keep warm feature once the probe sensor
reaches the set target temperature. This setting may be
changed to continue cooking if desired.
IMPORTANT
Setting the option for how the oven will heat once the
probe reaches the target temperature must be done
when the oven is inactive. The probe is not required to
be connected to the probe receptacle when setting this
option.
To set the oven to continue cooking after reaching
the target temperature:
1. Press keypad and hold for 6 seconds.
2. Press keypad and toggle until the
message appears (Fig. 2) then press
To set the oven to automatically stop cooking and
start keep warm once reaching target temperature:
1. Press keypad and hold for 6 seconds.
2. Press keypad and toggle until
message appears (Fig. 3) then press
"
Continu
to accept.
Fig. 2
" "
CAnCEL
to accept.
Fig. 3
"