Genie GPS-IC Series Owner's Manual page 16

5. Install door braces
(See
CAUTION
below).
Attach channel/rail assembly to header
bracket (Fig. 2-13).
• Fasten header end of the channel/rail to the
header bracket with pin.
• Install speed nut onto pin (Fig, 2-14).
• Place cardboard packing under power head. Use
additional support if needed.
.
Establish power head mounting height (Fig. 2-15).
• Power head should be at door height above floor
or higher.
• Temporarily support power head in this position,
Use
.
Header
Door
bracket
Power head
(Protected by cardboard
or packing)
- rope.
- ladder with cardboard packing.
- wood.
Critical height is point where the rail/channel attaches to power head.
CORRECTf
m
....... !ii!_i'ii_i_!ii!'i_i!7!i!!'i_i!!J!_i_i!!i!i _i_!i!!'i:i!!i!!_i_i_!i!!'i:i!!i!!_i_i_! _i_!i!!'i:i!!i!!_i_i_!i!!'i:i!!i!!_i_i _i_!i!!'i:i!!i!!_i_i_!i!!'i:i!!i!!_i _i_!i!!'i:i!!i!!_i_i_!i!!'i:i!!i!! _!_!!_:_!!_!!_i_!_!!_:_ _i_!!_i!_i!_!_i_ _:_