Advertisement
.
Fasten rail to power head.
• Align mounting holes of sprocket saddle, rail
and power head frame.
• Insert the two (2) 5/16" x 1/2" hex head
screws[112], then two (2) No. 10-24 x 1/2" hex
head screws [69].
• Tighten screws.
_:opower
h®<_;_d _ o py_:w de p_'_per
whe
,J_ssen'MF_g
"
•
@Fs?
......... ,_,
6.
Use adjusting
bolt to set chain tension (Fig. 1-4)
• Chain should sag slightly but not so much that it
drags on the rail.
IMPORTANT
iNSTALLATION
INSTRUCTIONS
To reduce the risk of
severe injuryor death:
1. READAND FOLLOWALL SAFETY,INSTALLATION AND
OPERATIONINSTRUCTIONS. If you haveany questionsor
do not understandan instruction,call yourservice
representative.
2. Do Not installoperatoron an improperlybalanceddoor.An
improperlybalanceddoor could causesevereinjury.Repairs
and adjustmentsto cables,springassembly,and other
hardwaremust be made bya trainedservicepersonusing
proper tools andinstructions.
3. Removeall ropesand disableall locksconnectedto the door
before installingoperator.
4. Installdoor operator7feet or moreabove the floor.Mountthe
emergencyreleaseknob6 feetabove the floor.
5. Do Not connectthe operatorto the sourceof poweruntil
instructedto do so.
6. Locate the control button:
• Withinsight of door.
. At a minimumheightof 5 feet,so smallchildrencannot
reach it.
. Awayfrom all movingparts of the door.
7. Installthe entrapmentWARNINGlabelnext to the wall buttonor
console.Installthe emergencyreleasetag on, or next to, the
emergencyrelease.
8. The operatormustreversewhen the door contactsa 1-1/2inch
high objecton the floor at the centerof the doorway.This is about
the sizeof a 2" x 4" boardlaidflat.
Track Guided Doors
SEE SECTION 2A
Section Door With
1-Piece Door With
Curved Track Hardware
Horizontal
Track Hardware
/_/
StraightTrack
]
(HorizontalOnly)
'U"
Trackless
Doors
SEE SECTION 2B.
1-Piece
Door
Jamb Type Hardware
(No Track)
yi:÷-
iT"
"U"
1-Piece
Door
Pivot Type Hardware
(No Track)
"U"
Advertisement
