Controls - GE AJCH 08 ACB Owner's Manual And Installation Instructions

Aboutthe controlson theair conditioner--modelswith touchpads.
Appearance may vary.
]
Air ConditionerControls
Lightsbeside the touchpadsonthe airconditioner
controlpanelindicate the selectedsettings.
RemoteControl
Controls
Whenthe air conditioner i s turnedon,it will
automatically startin thesettinglast used.
O ON/ITOPo o
Turn,_ air c nditi net on and off.
Display
_k MODE
r On tile remote control, rise to set tile air
conditioner to COOL or FANmode.
On tile air conditioner controls, use to set
COOL or FANmode
at
HIGH,MED or LOW
tim speed. Indicator lights
on tile air
conditioner controls will show tile mode
and tan speed selected.
O TEMP Increase •/Decrease • Pads
Use to set temperature when in COOL
illode,
O an Speeds (Remote control only)
Use to set tile tim speed at
LOW,MED
or
HIGH.
O TIMER
ON--\._q/en tile air conditioner is off, it
can be set to automatically mrn on in half
an horn" to 24 hours at its previous setting.
Each touch will set the time in half horns
up to l0 and then in horns up to 24.
To cancel (CI,) tile On Timer press tile
ONpad again.
OFF--_A]mn tile air conditioner is on, it
can be set to automatically tm'n off in half
an hour t() 94 h()ms. Each touch
will
set
tile time in half hom_ up to l 0 and then
in hom_ up to 24.
To cancel (CI,) the OffTimer press the
OEEpad again.
To cancel tile time_; press tile
ONor OFF
pads/mtil tile display time disappears.
O SLEEP
Press to set tile air conditioner to run for
S hom_ before it automatically returns to
the previous setting.
X&]mn the sleep timer is set, the set
temperature will automatically increase
2°F atter tile second horn" then l °F each
hour over tile next two hotllS.
To cancel tile sleep mode, press tile
MODE
pad
or tile
SLEEPpad
a second time.
O Remote Control Signal Receiver
4
Remote Control
[] To ensure proper operation, aim tile
remote control at tile signal receixer
on tile air conditioner
[] Tile remote control si_mal has a range of
up t() 21 feet.
[] Make sm'e nothing is between tile air
conditioner and tile remote control that
could block the signal.
[] Make sure batteries are fl'esh and installed
con'ecflx_see tile Care
and gleaning
section.