Window Installation - GE AJCH 08 ACB Owner's Manual And Installation Instructions

mnstaJiation mnstructions
WINDOW INSTALLATION--OPTIONAL (cont.)
[] PREPAREWINDOW
[] Mark the centerline of the stool. Measure
from the centerline 1378" on both sides for
the panel cuts.
[] Measure 1278" from the centerline on both sides
for the sill support brackets.
Centerline
,stoo,
_._ 13 3/_,, . _,_
Sill
Centerline
[] INSTALL SILL SUPPORTS
[] Assemble the sill supports. Do not fully
tighten the spacer mounting screws at this
time.
Type B
Type E
suppo_
Spacer mounting
screws Type (A)
Spacer
[] Turn the bolts and tighten the lock nuts to make
the sill supports level or tilt down 1/8" to the
outside. Line up the "V" notch with 1278" marks.
Drill pilot holes and attach the sill supports.
Average sill
Sill s_ _/_
Spacer
Narrow sill
Adjusting bolt-_
Large washer_(;_)
(For use withwood
sills)
Offset sill (such as brick or stone)
[] Before attaching the sill supports, place
them on the window stool. Select the spacer
position that will place the spacer near the
outermost point on the sill. Tighten the
spacer mounting screws.
Screws are in position
Sill
support
"V" notch
NOTES:
• On narrow sills, there may not be enough room to
use the lock nut.
• A deep offset sill may require a longer adjusting
bolt than the standard hex head bolt provided.
• On wood sills use the large washer between the
bolt head and the sill. This prevents the bolt fro m
digging into the wood.
Sill
18