Adjust/Replacing Drive And Augers/Impeller Belts - Stanley 36SS Owner's Manual

Service Adjustments
36SS,
45SS
Check & Replacing the Transmission Drive Belt
If belt needsto be changedor altered for any reason,the
belt is located in the front of the snow blower behind the
discharge chute and in front of the wheels.
1. Removethe cover that is protecting the Stanly Snow
Blower's belts. Removethe screws and simply lift
up the cover.
2. Removethe black belt and replace with a new belt.
3. Attach the cover and all parts as they were when
taken off.
Check & Replacing the Augers/Impeller Belt
Thereare two located in the front of the snow blower
behind the discharge chute and in front of the wheels.
1. Removethe cover that is protecting the Stanley
Snow Blower's belts. Removethe screws and
simply lift up the cover.
2. Removethe two belt and replace with new belt or
belts depending on the belt's condition.
3. Attach the cover and all parts as they were when
taken off.
NOTE: Always change both belts at the same time.
Changingonly one belt can lead to performanceissues.
Also checkfor correct belt tension after changing belts.
Readjust if necessary.
Rev: 11/2010
18