Table of Contents
Advertisement
Adjusting Augers/Impeller Cable
Service Adjustments
AdjustingDriveCable
36SS,45SS
If tension seems to be too loose or too tight the
augers/impeller cables needsto be readjusted.
If tension seems to be too loose or too tight the drive
cables needsto be readjusted.
.
.
.
Loosenthe bolt above where the cable screws in
to the left side of the control panel.
Looseningthe
bolt enables the
cable to screw
in further,
which makes
the augers/
impeller handle
tighter.
Adjust the bolt and cable to the
necessaryadjustments.
1. Loosenthe bolt above where the cable screws in
to the right side of the control panel.
2. Looseningthe
bolt enables the
cable to screw in
further, which
makesthe au-
gers/impeller
handle tighter.
3. Adjust the bolt
and cable to the
necessary
adjustments.
Adjusting Shift Rod
The shift rod will be at a preset position from the
factory, but after use, or maintenance,the shift rod
may require occasional adjustment.
Signsof adjustment need:
1. The shift handle is movedto the F1position, and
when the engagement handle is pressed,the unit
does not move.
2. The shift handle is movedto the R1position, and
when the engagement handle is pressed,the unit
does not move.
If either of the above occur, it may be necessaryto
adjust using the following procedure:
1. Setthe transmission handleto the space between F1
and R1 as shown on the right.
Loosenthe 2 nuts on the adjustment turnbuckle.
3.
Removethe cover plate from the gearbox housing
(see page 19).
4. Adjust the rod by turning the turnbuckle until the
friction wheel aligns with the center of the circular
disk in front of the rubber friction wheel.
i!!lil
il_i!iil
[Siiii!iii!iii|iii!
!_lliili/!
Rev: 11/2010
17
Advertisement
Table of Contents
