Furuno FR-2135S Installation Manual page 57

Display pedstal
front panel
Figure 4-13 Display pedestal, front view
5. Loosen six screws to remove the front panel on the display pedestal.
6. Set the RP Board (14P0298) in the top slot of the pcb card case.
7. Run the connector from the card case in front of the GYRO CONVERTER
Board.
8. Plug the connector in J1 on the RP Board.
9. Fasten the ground wire from the connector at the location shown below.
RP Board
ARP Board
SPU Board
Figure 4-14 Display pedestal, top view
Display pedestal
Pan Head
Screw
M2.6X5
(2 pcs.) M-card
case lid
GYRO
INT Board
CONVERTER
Board
Fasten ground wire from connector to this screw.
(TOP VIEW)
J1
Route cable between ARP and SPU Boards.
(FRONT VIEW)
4-13
M-card base
RP connector
FRONT