Scanner Unit - Furuno FR-2135S Installation Manual

How to attach NH connector
HOW TO ATTACH NH CONNECTOR TO SIGNAL CABLE
NH connector wire
1 Insert NH connector
wire into NH connector
housing.

2.2 Scanner Unit

Fabricating multicore cable 660V-MPYCY-12/250V-MPYCY-
12 (JIS cable)
1. Shorten the multicore cable making the length from the cable gland to the cable
end inside the scanner unit 450 mm. Remove the vinyl sheath of the cable by
450 mm; the armor by 440 mm.
Figure 2-7 Fabrication of multicore cable 660V-MPYCY-12/250V-MPYCY-12
2. Turn off the ANT MOTOR SW on the scanner unit.
Shrink tubing
20mm
NH connector
housing
2 Cut shrink tubing
in 20 mm lengths and
slip onto each wire.
Figure 2-6 How to attach NH connector
Core
2
= 1.25 mm
Signal cable
(S03-74)
Figure 2-8 Scanner unit, bow view
Solder
3 Solder connector
to signal cable.
Armor
440 mm
Conductors
450 mm
Armor
Vinyl sheath
ANT MOTOR SW
Multicore cable
(250V-MPYCY-12 or
660V-MPYCY-12)
2-6
4 Heat shrink
tubing with solder-
ing iron.