Table of Contents
Advertisement
3. Open the left side cover on the scanner unit with the hex wrench (supplied).
4. Unfasten the cable gland for the multicore cable and remove the gasket and
flat washers.
5. As shown in Figure 2-9, slide the clamping gland, flat washers and gasket on
the multicore cable.
6. Fold back armor by 5 mm and pass it through the two flat washers as shown in
Figure 2-9.
Seal with putty
after tightening.
Vinyl sheath
Clamping gland
Figure 2-9 Passing clamping gland, washers and gasket on the multicore cable
7. Shorten conductors considering their locations on the terminal board STB-1.
8. Confirm that armor is grounded between two flat washers.
Gasket
Figure 2-10 Scanner unit, port side view
Armor (folded back)
Flat
Cable gland
washer
Flat
Flat
washer
washer
STB-1
RTB-801
2-7
Hide quick links:
Advertisement
Table of Contents
