Replacing A Core Switch Blade (Cr16-4); Figure 23 Removal And Replacement Of The Core Switch Blade (Cr16-4) - Brocade Communications Systems DCX 8510-4 Hardware Reference Manual

5
Core switch blade (CR16-4) removal and replacement
ATTENTION
Follow ESD precautions.
NOTE
The CR16-4 blade is compatible only with the Brocade DCX 8510-4.
1. Remove the chassis door.
2.
3. Label and then disconnect cables from the faulty core switch blade.
4. Open the ejectors by rotating them toward the center of the blade face. Pull the blade out of
FIGURE 23

Replacing a core switch blade (CR16-4)

Complete the following steps to replace the core switch blade.
ATTENTION
Follow ESD precautions.
NOTE
The CR16-4 blade is compatible only with the Brocade DCX 8510-4.
76
Unscrew the two thumb screws from the ejectors on the blade using the Phillips screwdriver.
Unscrew the left thumb screw until it pops out. This initiates a hot-swap request.
the chassis using the ejectors.
Removal and replacement of the core switch blade (CR16-4)
Brocade DCX 8510-4 Backbone Hardware Reference Manual
53-1002177-06