Installation Of The Brocade Dcx 8510-4; In This Chapter; Time And Items Required - Brocade Communications Systems DCX 8510-4 Hardware Reference Manual

Installation of the Brocade DCX 8510-4

In this chapter

Time and items required

You can set up and install the Brocade DCX 8510-4 in the following ways:
•
•
•
•
This chapter describes how to set up the Brocade DCX 8510-4 as a standalone unit. For
rack-mount installation instructions, refer to the appropriate manual as described in the following
table.
Table 2
the items required to complete the task based on a fully populated Brocade DCX 8510-4 (192 Fibre
Channel ports using the FC16-48 port blades). Configurations with fewer ports require less time.
These time estimates assume a prepared installation site and appropriate power and network
connectivity.
Brocade DCX 8510-4 Backbone Hardware Reference Manual
53-1002177-06
•
Time and items required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
•
Preparing for the Brocade DCX 8510-4 installation . . . . . . . . . . . . . . . . . . . 14
•
Unpacking and installing the Brocade DCX 8510-4 . . . . . . . . . . . . . . . . . . . 16
•
Items included with the Brocade DCX 8510-4. . . . . . . . . . . . . . . . . . . . . . . . 17
•
Providing power to the Brocade DCX 8510-4 . . . . . . . . . . . . . . . . . . . . . . . . 17
•
Port numbering . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
•
Chassis slots . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
•
Cable management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
As a standalone unit on a flat surface.
In a 19-in. Electronic Industries Association (EIA) cabinet, using a Brocade DCX 8510-4,
DCX-4S Rack Mount Kit (either a 27-31 in. or 18-34 in. kit depending on rack used).
In a chassis with the Port Side Exhaust Kit (provided) in an approved rack.
In a mid-mount telecommunications (Telco) rack, using the Mid-Mount Rack Kit available from
your Brocade DCX 8510-4 supplier.
describes the main installation and setup tasks, the estimated time required for each, and
Chapter
2
13