Replacing A Blower Assembly; Wwn Card Removal And Replacement; Figure 26 Removal And Replacement Of The Blower Assembly - Brocade Communications Systems DCX 8510-4 Hardware Reference Manual

FIGURE 26
'

Replacing a blower assembly

Complete the following steps to replace the blower assembly in a chassis.
1. Orient the blower assembly and slide it into the chassis, pushing firmly to ensure that it is
2. Verify that the power LED displays a green light.
3. Use the screwdriver or your fingers to tighten the captive screws.

WWN card removal and replacement

Use this procedure to remove and replace a WWN card.
NOTE
The World Wide Name (WWN) cards contain fully redundant circuits and normally do not require
replacement. Two WWN cards are located beneath the WWN bezel (logo plate).
Brocade DCX 8510-4 Backbone Hardware Reference Manual
53-1002177-06
Removal and replacement of the blower assembly
seated.

WWN card removal and replacement

5
81