Replacing A Cable Management Finger Assembly; Port, Application, And Encryption Blade Removal And Replacement; Figure 19 Removal And Replacement Of The Vertical Cable Management - Brocade Communications Systems DCX 8510-4 Hardware Reference Manual

5

Port, application, and encryption blade removal and replacement

FIGURE 19

Replacing a cable management finger assembly

Complete the following steps to replace the cable management finger assembly.
1. Position and tighten the three (3) screws to secure the vertical cable management finger
2. Arrange the cables along the cable management finger assembly.
3. If necessary, repeat steps 1 and 2 for the other cable management assembly.
4. Replace the chassis door.

Port, application, and encryption blade removal and replacement

This section describes how to remove and replace port, application, and encryption blades. It does
not cover the core (CR) blades or the control processor (CP) blades.
60
Removal and replacement of the vertical cable management finger assemblies
assembly to the rack upright.
Brocade DCX 8510-4 Backbone Hardware Reference Manual
53-1002177-06