Ipv6; Static Ipv6 Route Configuration; Configuring A Static Ipv6 Route - Brocade Communications Systems ICX 6650 Configuration Manual

IPv6

Table 73
in the Layer 2 and full Layer 3 software images, except where explicitly noted.
TABLE 73
Feature
IPv6 static routes
IPv6 over IPv4 tunnels
ECMP load sharing

Static IPv6 route configuration

You can configure a static IPv6 route to be redistributed into a routing protocol, but you cannot
redistribute routes learned by a routing protocol into the static IPv6 routing table.
Before configuring a static IPv6 route, you must enable the forwarding of IPv6 traffic on the Layer 3
switch using the ipv6 unicast-routing command and enable IPv6 on at least one interface by
configuring an IPv6 address or explicitly enabling IPv6 on that interface. For more information on
performing these configuration tasks, refer to the section "Configuring IPv4 and IPv6 protocol
stacks" in the Brocade ICX 6650 Administration Guide.

Configuring a static IPv6 route

To configure a static IPv6 route for a destination network with the prefix 2001:db8::0/32, a
next-hop gateway with the global address 2001:db8:0:ee44::1, and an administrative distance of
110, enter the following command.
Brocade(config)#ipv6 route 2001:db8::0/32 2001:db8:0:ee44::1 distance 110
Syntax: ipv6 route dest-ipv6-prefix/prefix-length next-hop-ipv6-address [metric] [distance number]
To configure a static IPv6 route for a destination network with the prefix 2001:db8::0/32 and a
next-hop gateway with the link-local address 2001:db8::1 that the Layer 3 switch can access
through Ethernet interface 1/1/3, enter the following command.
Brocade(config)#ipv6 route 2001:db8::0/32 ethernet 1/1/3 2001:db8::1
Syntax: ipv6 route dest-ipv6-prefix/prefix-length [ ethernet stack-unit/slot/port | ve num ]
To configure a static IPv6 route for a destination network with the prefix 2001:db8::0/32 and a
next-hop gateway that the Layer 3 switch can access through tunnel 1, enter the following
command.
Brocade(config)#ipv6 route 2001:db8::0/32 tunnel 1
Syntax: ipv6 route dest-ipv6-prefix/prefix-length interface port [metric] [distance number]
Brocade ICX 6650 Layer 3 Routing
53-1002603-01
lists the IPv6 features Brocade ICX 6650 devices support. These features are supported
Supported IPv6 features
next-hop-ipv6-address [metric] [distance number]
Brocade ICX 6650
Yes
Yes
Yes
Chapter
8
401