Accessories; Installation - Kenmore 407.83126 Use & Care Manual

On initial unit setup, check that all the accessories listed below are included:
Exhaust Hose Windo_v Hose 5' Exhaust Hose
Adapter Adapter
3-Piece Window Kit
Window Kit Adapter Remote Control
2 AAA Batteries
IMPORTANT: The window kit and exhaust hose must be installed for proper opera-
tion (Fig. 3)
1. To avoid damage, place the unit in an upright position for at least 12 hours be-
fore initial operation. This ensures all lubricating oil has settled to the bottom of
the compressor, avoiding damage to internal parts.
2. Fully extend both ends of the exhaust hose approximately 6 inches, then screw
both hose adapters onto each end of the exhaust hose in a clockwise direction
until firmly secured.
3. Attach the hose to the unit by turning the exhaust hose adapter clockwise and
locking into the tabs around the exhaust hose holder.
4. Attach Window Kit Adapter to Window Exhaust Adapter by aligning the tabs
then slightly turn clockwise to secure.
5. Plug the unit into a 120V_60Hz grounded electrical outlet. DO NOT USE A
REGULAR EXTENSION CORD.
Locking Tabs
Rotate Exhaust Hose Adapter Clock-
wise to lock into place
9