Air Conditioner Operation; Cool Mode; Dry Mode; Fan Mode - Kenmore 407.83126 Use & Care Manual

IMPORTANT: After switchingthe unit on, the ventilator fan operates, but the compressorwill
not start for approximately three minutes.Cool air will begin to blow once the compressor
starts, but it may take another 5 minutes to feet the effect in the room. Thisfeature helps pro-
long the life of the compressor.Furtherinformation is available in the "Troubleshooting" sec-
tion. Do not touch the louvers as it could result in damage. Thts unit features automatic air
flow adjustment and is activated when the unitis powered on.
COOL MODE
• Place the unit {n the room that requires cooling.
We recommend starting your unit early in the morning on warm days for maximum
effect. This unit has a self-evaporation system to eliminate water that condenses in the
unit during cooling. The exhaust hose must be connected and properly installed to cool
the room properly. See the INSTALLATION instructions on page 9-10 of this USE AND
CARE GUIDE.
Use the MODE button on the unit control panel or remote and set to COOL. Adjust the
set temperature using the up and clown buttons on the unit or - and + buttons on the
remote. The cooling temperature can be set from 61°F to 86°F.
Using the remote control, press FAN button to adjust fc_n speed from Auto, Low, Med or
High.
DRY MODE
, Place the unit in the room that requiresdehumidification.
The exhaust hose must be connected and properly installed to dehumidify the room
properly. See the INSTALLATION instructions on page 9-10 of this USE AND CARE
GUIDE.
Use the MODE button on the unit control panel or remote and set to DRY.
• The fan speed is set to low and cannot be adjusted in DRY Mode.
• The compressor will run continuously when the unit operates in DRY mode.
• There is a built-in defrost control that senses frost buildup on the evaporator coils. During
defrosting, the compressor will automatically turn off. The fan will continue running to
defrost the coils. Once the frost has been removed, the compressor will re-start.
NOTE: The set temperature will not appear on the unit display. The set temperature and fan
speed cannot be adjusted while operating in this mode.
FAN MODE
• Place the unit in the room that requires fanning or air circulation.
• Use the MODE button on the unit control panel or remote and set to FAN. Using the
remote control, press FAN button to adjust fan speed from Auto, Low, Med or High.
• The fan auto settingwill change the fan speed to either High or Medium, depending on
the last setting of the cooling mode set temperature.
NOTE: The set temperature will not appear on the unit display and cannot be adjusted while
operating in this mode.
]S