Updating System Bios - NEC 120Le Installation Instructions Manual

When replacing the thermal pad, remove the old thermal pad
completely from the CPU and the bottom of the heat sink.
Always replace the thermal pad with a new pad.
7. Repeat this procedure if you installed a new thermal pad or adjusted the
position of the heat sink. Once the CPU2 Temp is within the ranges
specified in Step 3 of this procedure, perform the next step.
8. Verify POST has not displayed any error messages. If POST error messages
are displayed, refer to the POST Error Codes and Messages table located in
Chapter 5 or your system user's guide.

Updating System BIOS

for detailed information on changing BIOS settings.
1. Power-on or reboot the system. "Press <F2> to enter SETUP" displays.
2. Press F2. The BIOS Setup Utility starts and the Main Menu is displayed.
3. Select "Advanced."
4. Select the "CPU Reconfiguration" submenu.
5. Verify CPU #2 is set to "Normal."
6. Return to the Advanced Menu.
7. Select "Advanced." The Advanced Submenu displays.
8. Select "Reset Configuration Data" and change this setting to "Yes".
9. Exit BIOS Setup saving the change made in this procedure. Your system
reboots.
14 120Le Pentium III Processor Installation
! CAUTION
Note:
Refer to Chapter 3 of your system user's guide