Resource Configuration Add-In (Rca) Window - NEC ES1400 User Manual

Resource Configuration Add-in (RCA) Window

The RCA provides three major functions:
T
Creates representations of devices that cannot be discovered
by the system (ISA cards)
T
Modifies the contents of the system by adding and removing
devices
T
Modifies the resources used by devices.
You can use the RCA window to define an ISA card or add an ISA
card by clicking on the appropriate button. Removing an ISA card
requires that the card be highlighted in the Devices section of the
screen before clicking on the button.
1. From the SSU main window, launch the RCA by selecting the
"Resources" task under the RCA heading in the task box. Click
OK.
2. When the RCA window appears, it displays messages similar
to the following:
Baseboard: System Board
PCI Card: Bus 00 dev 00 -- Host Processor Bridge
PCI Card: Bus 00 dev 0D –- Multifunction Controller
PCI Card: Bus 00 dev 0F –- Ethernet Controller
PCI Card: Bus 00 dev 12 –- SCSI Controller
PCI Card: Bus 00 dev 14 –- VGA Controller
3. To configure a device, select its name in the Devices section of
the RCA window, and press the spacebar or double-click on it.
4. Make configuration changes and click on OK to return to the
RCA window. Repeat Steps 3 and 4 to configure additional
devices.
5. Save all the changes made by clicking on the Save button.
Saving writes your current configuration to nonvolatile storage
where it will be available to the system after every reboot.
6. Close the RCA window and return to the Main Menu by
clicking on the Close button.
System Setup Utility B-7