Advertisement
Available languages
Available languages
SOLUTUON
• Raise water heater thermostat
to 140°F
if necessary°
CAUSED
BY
• Water is not hot
PROBLEM
Dishes not dry
Spotting"'and .....
filming
• COOL DRY option
selected
• Improper loading
. Rinse agent
dispenser
empty
• Hard water
• Water is not hot
• COOL DRY option
selected
.Not enough or
poor quality
detergent
• Old detergent
• No rinse agent
. Do not select COOL DRY option_ Allow
dishes to dry in heated air°
• Load dishes so items drain properly., Avoid
overloading.
• Fill rinse agent dispenser
if empty_
...........
:Fiii
detergent cups tocapacity:
LJse-dishwasher
detergent with highest available phosphorous
content. May be necessary to install a water
softener.
• Raise water heater thermostat
to I40°F.
. Drying without heat may cause some
spotting° Do not select COOL DRY option.
° Use more fresh automatic
dishwasher
detergent.
Use detergent
with highest
available
phosphorous
content,
especially
if you have hard water.
° Use only fresh, automatic
dishwasher
detergent,, Store tightly closed in a cool, dry
place. Discard old, lumpy or separated
detergent.
Do not fil! detergent
dispenser
until ready to wash
° Fill rinse agent dispenser
To remove stubborn
spots and film from
glassware:
,,
am
3
4_
Remove al! metal utensils from the
dishwasher_
Do not add detergenL
Select HEAVY WASH cycler
Start the dishwasher and allow to run for
18 to 20 minutes. The dishwasher
will
now be in the main wash.
5. Then open the door and pour 2 cups
(500 ml) white vinegar into bottom of
dishwasher_
6_ Close the door and allow to complete
the cycle,
If vinegar rinse doesn't work:
Repeat as
above, except use 1/4 cup (60 ml) of citric
acid crystals instead of vinegar. (Most
drugstores
carry citric acid crystals.)
15
Advertisement
