Care Of Surfaces - Kenmore 14071 Owner's Manual

CARE OF SURFACES
o Clean control panel with lightly
dampened cloth_ Dry thoroughly.
DO NOT use abrasives or sharp
objects--they could damage the
control panel.
• Clean outside cabinet finish with a good
appliance polish wax,. DO NOT use
scouring pads, harsh or gritty cleaners.
° Interior is self-cleaning with normal use.
if it should ever need cleaning, use a
mild cleansing powder. If hard water
causes lime build-up, clean as follows:
--Pour 2 cups white vinegar into empty
dishwasher. DO NOT use detergent.
--Operate machine on NORMAL WASH
cycle.
t:
PROTECTION AGAINST
FREEZING
If dishwasher is left in an unheated place
during the winter:
, Shut off water and electrical power.
° Remove access panel_
, Disconnect water lines from valve.
Drain into a flat pan.
• Drain collection chamber at rear of unit
below filter by disconnecting hose to
pump°
° Remove plastic pump cover in tub
bottom and use sponge to soak up any
remaining water.
• Reconnect water lines to valve and
hoses to pump_
Pump cover screws
CARE OF AiR GAP
If an air gap was installed for your built-in
dishwasher, check to make sure it is
clean. Air gaps are usually mounted on
the countertop and can be inspected by
removing the cover, The air gap is not
part of your dishwasher and is not
covered by Sears warranty.
Drain air gap
PREPARATaON FOR MOVING
, Disconnect electrical power.
° Turn off water supply, disconnect water
and drain lines°
° Tape racks in place; close door securely
and tape it shut.
o Wrap with blankets and, if using a hand
truck, lift dishwasher from side in upright
position only.
12