Advertisement
Available languages
Available languages
Converting to LP Gas (continued)
If It IS This Regulator:
Gas Flow
into
Do not
remove this
protective cap
except for
conversion.
Lever shown closed..
PULL TO OPEN.
Cap Assembly
1. Unscrew
the plastic-protected
hex-nut cap from the
regulator.,
2. Carefully
pry
the
protective
plastic
cap
off the
threaded
metal cap. Gently
pull the plastic
washer
off the threads
on the other side of the metal cap.
3. Push the plastic cap onto the end of the metal cap
displaying
the type of gas you are converting
too
Press the attached
plastic washer
onto the threads
on the other side of the metal cap.
4. Screw the hex-nut cap back into the regulator.
Do
not overtighten.
Step
2
Convert The Surface Burners
Follow the directions
in A for Sealed
Burner Models
(models without
lift-up cooktops)
or B,for Standard
Twin Burner Models
(models with lift-up cooktops)_
A Sealed Burner Modems
(models without lift-up cooktops)
........ Grate
|
Burner Cap
Drip Pan (on some models)
Burner Head
Electrode
1, Remove
grates,
burner caps and burner heads°
g
=
Remove
the brass orifice spud
inside
the
chimney
of
each
burner
using
a 9/32" or 7 mm
nut driver_
install the orifice spuds accord-
Chimney
ing to one of the following
dia -
grams (see [] or r_) for LP gas
or natural
gas,
depending
on
which you are converting
too
Orifice Spud
[_
Orifice
Spuds for Converting
to LP Gas:
LP orifice spuds are in a small plastic bag packed with
this Use and Care Manual, LP orifice spuds have a 2-
digit number
and the letter
"U' on top. Each orifice
spud
wilt also
have
1, 2 or 3 grooves
on the top,
denoting
the location
on the range where
it is to be
installed as shown below°
Front of Range
[]
Orifice
Spuds for Converting
to Natural
Gas:
Natural
gas orificespuds
have a 3-digit
number
and
the letter "N" on the top. Each orifice
spud will also
have 1,2 or 3 grooves on top denoting
the location on
the range where
it is to be installed
as shown below_
Front of Range
4. To prevent leakage,
make sure the orifice spuds are
securely
screwed
into the gas inlet tube&
5. Put old orifice spuds back in the bag to save for
possible future conversion_
NOTE;
If an orifice spud is acci-
dentally
dropped,
the cooktop
can be raised by disengaging
the
2 front clips with a large flat blade
screwdriver.
When lowering
it, make sure it snaps over the clips,
38
Advertisement
