Advertisement
Available languages
Available languages
UsBngYour Oven
Before Using Your Oven
Be sure you understand
how to set the control proper-
ly, Practice
removing
and replacing
the shelves
while
the oven is cool
Read the information
and tips on the
following
pages,, Keep this manual
handy
where
you
can refer
to it, especially
during
the first weeks
of
using your new ranger
Lighting Unstructions for
Standing Pilot Models
Some
models
have standing
oven pilots that must be
lit initially,
To light the oven
pilot:
1, Be sure the OVEN
CONTROL
knob is in the OFF
position,,
2, Open the broiler drawer
and remove the broiler pan
and rack, This will make it easier for you to reach
inside the broiler compartment,
3, Find the oven
pilot port at the back of the broiler
compartment.
The long tube, running from front to
back,
is the oven
burner° The pilot port is at the
back, about one inch below the burner,
4, Using a long match or match
holder,
reach in and
light the oven pilot,
oTo
light the
oven
burner,
turn the OVEN
CON-
TROL knob to the desired
temperature.
The burner
should
light within 60 seconds.
• Proper
flame
configuration,
while using the oven
burner, visually
check the burner flame in the broiler
compartment.
If flame does not burn as described
in
the Installation
section
of this manual,
adjust
the
flame following
the directions
on those page&
o Power
failure:
An electrical
power failure
wilt not
affect a lighted standing
oven piloL
Lighting instructions for
Electric ignition Modems
The oven burner is lighted
by electric
ignition
(on
some models).
To light the burner, turn the OVEN CONTROL
knob
to the desired
temperature.
The burner should
ignite
within 30_90 seconds,,
After the oven reaches the selected
temperature,
the
oven burner cycles--off
completely,
then on with a full
flame--to
keep the oven temperature
controlled°
Power Outage
CAUTION:
Do not make any attempt to operate the
electric ignition oven during an electrical
power fail-
ure_ The oven or broiler cannot be lit during a power
failure° Gas will not flow unless the glow bar is hot,
If the oven is in use when a power failure occurs, the
oven burner shuts off and cannot be re-lit until power
is restored,.
Oven Controm
The OVEN CONTROL
knob is
located
on the control
panel on
the front of the range,
Simply
turn
the knob
to the
desired
cooking temperatures.
it will normally
take 30-90 sec-
onds
before
the flame
comes
on. After the oven reaches
the
selected
temperature,
the oven
burner
cycles--off
completely,
then
on with a full flamemto
maintain
the selected
tempera-
ture,,
I
Oven Light (onsomemodels)
Use the switch on the control
panel to turn the oven
light on and off,
10
Advertisement
