Maytag MED / GD 9700S Technical Education page 38

g) Lift the top locking tab of the motor
harness plug and pull the top pins away
from the motor connector, then release
the bottom tab, and remove the plug.
Top Locking Tab
h) Remove the two hex washer-head
mounting screws from the drive motor,
then lift the right side of the motor
slightly, pull the two tabs on the left side
out of the chassis slots, and remove the
drive motor.
Hex Washer-Head Screws
Motor Harness Plug
4-9
9. To remove the belt switch:
a) Remove the 3/8 inch hex shoulder-
washer screw from the idler pulley as-
sembly and remove the assembly.
Idler Pulley Assembly
b) Remove the two screws from the belt
switch and remove it from the motor.
c) Disconnect the blue wires from the belt
switch terminals.
Blue Wire
Belt Switch
3/8 inch Hex Shoulder
Washer Screw
Belt Switch Screws
Blue Wire