Maytag MED / GD 9700S Technical Education page 18

2
Connect ground wire (green or bare) of direct wire cable to
external ground conductor screw. Tighten screw.
2 3456789 7 8  85 7 76
2 7 8 76  7668 7 976   67    7
2  2 ! "# 56 5798 76 6
$2 68567  %67& 76 567!89  ' 76
32 (6579 7 8 76
) 2 (6579 76 *56 7 68567 76
32
Place the hooked ends of the other direct wire cable wires
under the outer terminal block screws (hooks facing right).
Squeeze hooked ends together. Tighten screws.
42
Tighten strain relief screw.
52
Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw.
62
Y ou have completed your electrical connection. Now go to
"Venting Requirements."
123456789 68 49 7 936577895
789 9 9  98 9  9 9 
  9   92
2 +&76 76659 6 (3, 56 -&+-.
2 +&76  
2 (6579 7 8
$2 /96 567!89  5*  5786 68
32  2 ! "# 56 5798 76 6
) 2 .8 567!89 
2 (6579 *56 7 68567 76
2
Loosen or remove center silver-colored terminal block screw.
2
Connect neutral wire (white or center wire) of power supply
cord to the center, silver-colored terminal screw of the
terminal block. Tighten screw.
2 3456789 7 8  85 7 76
2 (6579 7 8 76
2 68567  %67& 76 567!89  ' 76
$2 (6579 76 *56 7 68567 76
32  2 ! "# 56 5798 76 6
2
Connect the other wires to outer terminal block screws.
Tighten screws.
32
Tighten strain relief screws.
42
Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw.
52
Y ou have completed your electrical connection. Now go to
"Venting Requirements."
123456789 68 49 74568 73456
789 9 9  98 9  9 9 
  9   92
Direct wire cable must have 5 ft (1.52 m) of extra length so dryer
can be moved if needed.
Strip 3 / " (8.9 cm) of outer covering from end of cable. Strip 2
insulation back 1" (2.5 cm). If using 3-wire cable with ground
wire, cut bare wire even with outer covering. Shape ends of wires
into a hook shape.
2-9