Troubleshooting; Tips For Energy Saving; Operating Range - Sanyo KMS0912 Instruction Manual

If your air conditioner does not work
still does not work properly, contact your dealer or service
Trouble
Air conditioner does not
run at all
Compressor runs but
soon stops
Poor cooling peformance
Do not:
Do
01-352-15

Troubleshooting

properly, first check the foilowinq points before requesting service. If it
Possibto Cause
Power failore
2. Leakaoe breaker tripped
3. Line voltaoe too low
Operation button is Off
4
Batteries tn remote control unit
5.
have run down
Obstruction in front of condenser
1.
coil
Dirty or clogged air filter
1
Heat source (cooker, heater, or
2.
electrical appliance) or many
people in room
Doors and/or windows are open
3.
Obstacle near air intake or air
4.
discharge port
Thermostat is set too high
5.

Tips for Energy Saving

Block the air intake and outlet of the unit. If it is obstructed,
the unit will not work well, and may be damaged.
Let direct sunlight into the room. Use sunshades, blind or curtains.
If the walls and ceiling of the room are warmed by the sun, it will
take longer to cool the room.
Always try to keep the air filter clean. (Refer to "Care and Cleaning").
A clogged filter will impair the performance of the unit.
To prevent conditioned air from escaping, keep windows, doors and
any other openings closed.

Operating Range

Temperature
Maximum
Cooling
Minimum
centre.
Restore power
1
Contact service centre
2.
Consult with electrician or dealer
3.
Press the button again
5.
1. obstruction
Clean air filter to improve airflow
1.
Eliminate heat source if possible
2.
Shut them to keep the heat out
3.
Remove it to ensure good airflow
4.
Set the temperature lower
5.
Indoor air intake
95 0 F DB/-
750F WB
670 F DB/-
570F
Remedy
Outdoor airintake
1150 F DB
670 F DB
15