Advertisement
Cleaning The Burner Tubes and Burner Ports
To reduce the chance of FLASHBACK
the proce-
dure below should be followed at least once a month
in late summer or early fall when spiders are most
active or when your grill has not been used for a
period of time.
1. Turn all Burner Valves to the full OFF position.
2. Turn the LP gas tank valve to the full OFF position.
3. Detach the LP gas regulator assembly from your
gasgrill.
4. Remove the Cooking Grids, FlameTamers, and
Grease Trays from your grill.
5. Remove the Cotter Pin from the rear underside of
each Burner using a pair of long nose pliers.
6. Carefully lift each Burner up and away from the
Gas Valve Orifice.
7. Checking and cleaning burnedventuri tubes for
insects and insect nests. A clogged tube can lead
to a fire beneath the grill.
8. Refer to Fig. 1 and perform one of these
three cleaning methods:
Bend a stiff wire, (a lightweight
coat
hanger works well) into a small hook as
shown below. Run the hook through the
Burner Tube and inside the Burner several
times to remove any debris.
Use a bottle brush with a flexible
handle.
Run the brush through the Burner Tube
and inside the Burner several times,
removing any debris.
Use an air hose to force air through each
Burner Tube. The forced air should pass
debris or obstructions
through the Burner
and out the Ports.
Regardless of which Burner cleaning procedure you
use, we recommend you also complete the following
steps to help prolong Burner life.
1. Use a fiber pad or nylon brush to clean the entire
outer surface of each Burner until free of food
residue and dirt.
2. Clean any clogged Ports with a stiff wire, such as
an open paper clip.
.
Inspect each Burner for damage (cracks or holes)
and if such damage is found, order and install a
new Burner. After installation, check to ensure
that the Gas Valve Orifices are correctly placed
inside the ends of the Burner Tubes. Also check
the position of your Spark Electrode.
Z WARNING
The location of the Burner Tube with respect
to the Orifice is vital for safe operation.
Check to ensure the Orifice is inside the
Burner Tube before using your gas grill. See
Fig. 2. If the Burner Tube does not fit over
the Valve Orifice,
lighting the Burner may
cause explosion and/or fire.
Figure 2
GAS VALVE ASSEMBLY
ORIFICE
BURNER TUBE
Figure 1
J
HEAT-INSULATING
RING
SPARKELECTROOEAS-
SEMBLY
BURNERTUBE
GAS COLLECTOR
BOX
BURNER
BURNER PORT
/f
/t
ooooooooooooo/o
o
o
o
o
oooodoo
_J
FOOT
/
COTTERPIN
28
Advertisement
