Advertisement
_llnstalling
The Grill Head
1. Now that you've assembled
the grill cart you
can install the pre-assembled
Grill Head. See
Fig. 6a or 6b. If you haven't already done so,
we suggest you open the Grill Lid and remove
the packed components.
Even with the compo-
nents removed,
this next step requires 2
people.
BE CAREFUL
NOT TO PINCH FINGERS
WHEN LOWERING
HEAD ONTO CART
2. For LP Gas grills:
With an assistant,
lift and position the Grill
Head onto the grill cart. Place the Side Burner
Gas Valve Assembly through the slot in side of
Grill Head as illustrated in Fig. 6a. Align the 4
holes of the Bowl Side Panel to the threaded
holes on the Cart Leg Bracket.
Thread the Electric Wire into the Wire Fastener.
Secure Wire Fastener to Right Rear Bowl location on
Grill Head using 1 of the 1/4"xl/2"
Pattern Head
Screw. Finish securing Grill Head to Cart using 3 of
the 1/4"xl/2" Pattern Head Screws provided.
3. For Natural
Gas grills:
With an assistant,
lift and position the Grill
Head onto the grill cart. Place the Side Burner
Gas Valve Assembly and Electric Wire through
the slot in side of Grill Head as illustrated in
Fig. 6b. Align the 4 holes of the Bowl Side
Panel to the threaded
holes on the Cart Leg
Bracket. Secure firmly
by using 4 of the 1/4"x
1/2" Pattern Head Screws provided.
Figure 6a (LP gas model only)
GRILL
HEAD
BOWL
SIDE
PANEL
ELECTRIC
WIRE
FROM
GRILL
HEAD
CARTLEG
BRACKET
WiRE FASTENER
FROM C
_\
VALVE ASSEMBLY
LEFT CART LEG
_HT CART LEG
Figure
6b (Natural
gas
model
only)
GRILL
HEAD
/
%\
BOWL
SIDE PANEL
CARTLEG
BRACKET
\
\
Imlnstalling
Lighting
Stick
1.
Attach the Lighting Stick to the Left Bowl
Support Bracket as shown in Fig. 7.
Align the hole at the end of Lighting Stick
Wire with the threaded hole on the Left Bowl
Support Bracket. Tighten securely using the
M4x8mm Pattern Head Screw.
LEFT CART LEG
BURNER
GAS
VALVE ASSEMBLY
ELECTRIC
WIRE
FROM
GRILL
HEAD
_'RIGHT
CART
LEG
Figure 7
LEFT OUTSIDE
BOWL PANEL
M4x8mmPATTENN_
HEAD SCREW
UGHTtNG
STICK
16
Advertisement
