Download Print this page

Kenmore 141.153371 Owner's Manual page 22

Liquid propane and natural gas grill

Advertisement

[]
Connecting
A Liquid Propane Gas (LPGas)
--Tank
To Your Grill
1. Open the Doors of cabinet.
Pull out the LPG
Tank Pull-Out
Tray. Place a 20 Ib tank with
foot ring into Me hole in the tray. See Fig. 13a.
Make sure the tank valve is in the OFF
positon.
2. Align the tank so the Tank Valve faces the
rear right corner of cabinet.
Use the
5/16"x3-1/2"
Wing
Bolt to secure gas tank
from rear of tray. See Fig. 13a.
3. Check the Tank Valve to ensure it has proper
external
mating threads to fit the Hose &
Regulator assembly provided
(Type 1 connec-
tion per ANSI Z21.58b-2002).
See Fig. 13b
4. Inspect the valve connection port of the Regulator
assembly. Look for damage or debris. Remove any
debris. Inspect Hosefordamage.
Never usedamaged
or plugged equipment.
5. Make sure all Burner Knobs are in the OFF
position.
6. Connect the Hose and Regulator assembly to the
Tank valve (See Fig. 13b). Hand tighten Quick Cou-
pling Nut clockwise to a full stop. DO NOT use a
wrench to tighten because it could damage the Quick
Coupling Nut and result in a hazardous condition.
7. Open the Tank Valve fully (counterclockwise).
Use a
soapy water solution to check all connections
for
leaks before attempting to tight your grill. See "Check-
ing for LP Gas Leaks" on page 23. If a leak is found,
turn the Tank Valve off and do not use your grill until the
leak is repaired.
Figure
13a (LP Gas model only)
GRILL HEAD
DOOR
'\
J
_f"
GASTANK
/
TANK PULL-OUT
TRAY
Figure 13b (LP Gas model only)
GRILL HEAD
Disconnecting
A Liquid Propane Gas (LP Gas)
Tank From Your Grill
1. Turn the Burner Knobs and LP Gas Tank
Valve to the full OFF position. (Turn clockwise
to close.)
2. Detach the Hose and Regulator assembly
from
the LP Gas Tank Valve by turning the Quick
Coupling
Nut counterclockwise.
See Fig.13b
CAUTION: When the appliance is not in use, the
gas must be turned off at the supply tank.
DOOR
\
\
\
TANK PULL-OUT
TRAY//
\
/f
QUICK COUPLING
NUT
\
Type
1
\
connection
ALREADY
CONNECTED
per ANSI
TO ADAPTOR
UNDER
Z21.58b-2002
SiDE BURNER.
22

Advertisement

loading

This manual is also suitable for:

141.173371