Adjusting The Lumbar Support - Renault Scenic Handbook

dRIVER's sEAT WITh ELEcTRIc cONTROLs
Switch 4 is used for adjusting the seat
base and switch 3 is used for adjusting
the seatback. On equipped vehicles,
buttons 2 store the chosen driving posi-
tion (refer to the following page).
Adjusting the seat position
To move the seat forwards or back
Move switch 4 forwards or backwards.
To raise or lower the seat base
Move switch 4 upwards or downwards.
Adjusting the seatback
To tilt the seatback, move the top of
switch 3 forwards or backwards.

Adjusting the lumbar support

on the driver's seat
Raise or lower handle 5 to increase or
decrease the support.
Make sure that the seat-
backs are correctly locked
in place.
1.18
2
3
1
4
heated seats
(depending on vehicle)
With the engine running, turn control 1
to either position 1, 2 or 3 (depending
on the temperature required). An in-
dicator light on the instrument panel
lights up once the front seat heating
system is operating.
The system, which has a thermostat,
decides whether or not the heating is
needed.
5
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
We would advise you not to recline
the seatbacks too far to ensure that
the effectiveness of the seat belts is
not reduced.
Nothing should be placed on the
floor (area in front of driver) as such
objects may slide under the pedal
during braking manoeuvres, thus
obstructing its use.