Kenmore Side by Side Refrigerator Use & Care Manual page 27

ICEMAKER IS NOT PRODUCING ICE
Check if,°. Then,,,
The icemaker feeler arm is up in the STOP (up) Lower arm to ON (down) position_
position°
The freezer is not cold enough to produce ice.
The water supply shutoff valve is turned off,
disconnected or the water tubing is clogge&
The icemaker mold has no water in it.
__m
The water pressure seems too low or too high.
Allow 24 hours after the refrigerator is installed for the
icemaker to begin producing ice.
Check the water supply connection in your house and turn
on the water supply if necessary. Unclog tubing°
The water supply is incorrectly installed or not connected.
See Water Line installation Instructions. Use only copper
tubing Do not use piercing-type valve&
The icemaker needs to be connected to a cold water line
with water pressure between 20 and 120 p.sJo on models
without a water filter and between 40 and t20 p_s.i, on
models with a water filter.
Supply line is clogged., Call a plumber.
Shutoff valve is not turned on. Turn on shutoff valve.
SMALL OR HOLLOW ICE CUBES
Check if.,. Then.°.
[ Water filter is clogged, l Replace filter cartridge or remove filter and instal! plugo J
WATER IS SPURTING FROM DISPENSER
Check if... Then.°°
Newly-insta,led filter. I Run water fr°m the dispenser f°r tw° minutes [ab°ut one Igal,on (3.8 ,iters)].
WATER IN FIRST GLASS IS WARM
Check if,.. Then..,
The refrigerator was recently plugged in and Allow about 24 hours for water to cool to proper
the temperature controls were seL temperature,,
Water dispenser has not been used for an Water in first glass will not be as cool as in succeeding
extended period glasses,
Water system has been draine& Allow several hours for replenished supply to get cold,,
ORANGE GLOW IN FREEZER
Check if... Then..°
Defrost heater is on. Refrigerator is operating normally. Check for glow again
in 30 minutes. The defrost heater should cycle off within
30 minutes_
27