Kenmore 30 Owner's Manual page 8

Inserting the Door Panels
I. Loosen the Top Trim on the freezer and fresh
food doors.
o Using a T-20 Tozx driver, loosen the two screws
attaching the Top Trim about I/4" (6 ram).
2. Insert the panels.
Top freezer panel and fresh food panel
o Lift the Top Trim up !14" (6 mm) and carefully push
the top freezer panel in until it slides into the slot
behind the door handle. Push the filler panel
(requi_ed with some door panels) in behind the
decorator panel. Repeat for fresh food panel.
Bottom freezer panel
° Carefully push the panel in until it slides into the
slot behind the door handle° Push the fillet panel
(required with some door panels) in behind the
decorator' panel.
3. Tighten the two screws on the Top Trim to 30
in-lbs torque.
4. Install the Side Trim. These pieces are tucked
inside the fresh food door handle.
Do not remove the protective film on the outside
of the Side Trim until the Side Trim is installed°
o Fit the bottom of the Side Trim under the Bottom
Trim as illustlated.
o Hold the Side Trim against the front face of the
decorator panels and fit the Side Trim under the Top
Trim. Make sure the Side Trim is fitted correctly and
that you are satisfied with the appearance of all the
parts before pulling the blue tape liner'.
5. Secure the Side Trim.
o Place one hand between the two pieces of blue tape
liner and hold the Side Trim firmly against the panels
and the side of the door.
° Pull the top blue tape liner up about 3" (8 mm),
pressing the trim with your hand as the adhesive is
exposed to the door. Then pull the bottom blue tape
liner' down about 3" (8 ram)° Follow the tape with
your hand, pressing the trim adhesive against the door.
° Continue pulling the tape liner' loose, alternating
between the top and bottom and pressing the Side
Trim against the dooL
6. Remove the protective film from the outside of
the Side Trim.
Blue
Tape
Liner
Side
Trim
!
Cut-Out
Side
Trim