Kenmore 30 Owner's Manual page 18

Uce and Nater Dispenser
To Dispense Rce and Water
o Select CUBES, CRUSHED
ICE (on some models)
or WATER_
o Grip the glass or other container
near the rim and press the rim
against the center of the pad..
, After crushed ice is dispensed,
some water may drip from the chute. The spill shelf
is not self-draining. The shelf and its grille should be
cleaned regularly according to the Care and Cleaning
instructions_
To Remove ace Storage Bin
Lift the left corner to flee the
bin fi'om the shelf[ Pull the bin
straight out while suppmting it
at f_ont and back_
To Replace Dee Storage Bin
Slide the bin back until the
tab on the bin locks into the
slot in the shelf_
If the bin does not go all the
way back, remove it and turn
the drive mechanism t14 turn.
Then push the bin back again
until the tab on the bin locks
into the slot in the shelf.
Drive
Mechanism
Crushed ice
o Some crushed ice may be dispensed even though you
selected CUBE& This happens occasionally when a
few cubes get channeled to the crusher.
o Sometimes a mound of snow "will form on the door
in the ice chute, Th'is condition is normal, and
usually occurs when you have dispensed crushed
ice repeatedly. The snow will eventually evaporate.
• Sometimes crushed ice will spray beyond the glass,
To avoid this, hold the glass up close to the chute.
Water
° On models with a water dispenser, if no water is
dispensed when the refrigerator is first installed,
there may be air in the water line system. Press the
dispenser pad for at least two minutes to remove
trapped air fEom the water line and to fill the water
system.
o The first glass of water dispensed may be warmer
than the following ones. This is normal.
° Dispensed wa, er is cool, not iced_ For colder water,
simply add crushed ice or cubes before dispensing
water_
CAUTION: Never put fingers or other objects
into the dispenser opening.
18