Kenmore Three-Speed Triple Dispenser Automatic Washers Owner's Manual & Installation Instructions page 14

C. CONNECr DRAIN HOSE
Proper connection of the drain hose
will protect your floors from damage
due to water leakage.
STF'P 1. To prevent the drain hose from
coming off or leaking, it must be installed
per the following instructions:
IMPORTANT: 7[-0ensure proper installa-
tion, this procedure must be followed
exactly.
a. Wet the inside of the straight end of
the drain hose with tap water. DO
NOT USE ANY OTHER LUBRICANT.
b. Squeeze ears of silver, double-wire
clamp with pliers to open. Place clamp
over the straight end of the drain hose
1/4inch from the end.
d. Place clamp over area marked
"CLAMP;.' Release clamp.
/T WIST
AND
PUSH
\\
c. Open clamp. Twist hose back and
forth while pushing down onto drain
connector at the bottom of the washer.
Continue until hose contacts the
ribbed stop on the cabinet.
If you have: You will need to buy:
Drain hose that is too short Drain hose, Part No. 388423 and hose
kit, Part No. 285442
Drain hose that is too long Hose kit, Part No. 285442
A problem with lint clogging your drain Drain protector, Part No. 367031
Parts listed are available from your local Sears store or Sears Service Center.
Call 1-800-366-PART (1-800-366-7278).
14