Kenmore 790.9010 Series Use & Care Manual page 27

Changing Oven
Do not turn the
and/or Cooktop Lights elf e qulppedl
oven light on during the self-cleaning cycle. High temperature will reduce lamp life.
To Change the Oven Light
The oven light automatically turns on when the door is opened (some modets). To turn
the oven light on and off when the door is closed, use the OVEN LIGHT switch located
on the control panel.
1. Turn electrical power off at the main source or unplug the oven.
2. Wear a leather-faced gtove for protection against possible broken glass.
3. Press wire holder to one side to release the glass shield.
4. Replace butb with a new 40 watt appliance butb.
5. Replace gtass shield in socket and snap wire holder into place.
6. Turn power back on at the main source (or plug the appliance back in).
7. The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer
in the ELECTRONIC OVEN CONTROL section of this manual.
Be sure all surface element control knobs are turned off and elements
are cool.
To Change the Cooktop Light (If equipped)
Your model will either have a canopy cover that lifts up or 2 phillips head screws that
secure the light cover. BEFORE CHANGING THE COOKTOP LIGHT, BE SURE TO
TURN THE POWER OFF AT THE MAIN SOURCE OR UNPLUG THE RANGE.
To remove and replace the fluorescent llght:
1. Lift up the control panel coven
2. Place your fingers on the tube at approximately 8" (20.3 cm) from each end.
3. To remove, turn the tube 90 ° then putt it out of its sockets.
4. Engage the new tube into the sockets, then rotate and snap it in place.
Adjusting Oven Temperature
NOTE: The adjustments made will not change the self-cleaning temperature.
When first using the oven, be sure to follow recipe times and temperatures, if you think the oven is cooking too hot
or too coot for your recipes, the temperature can be adjusted. Before adjusting the oven temperature, test a recipe
by using a temperature set higher or lower than the recipe recommended temperature. The baking results should
help you to decide how much of an adjustment is needed.
To Adjust the Oven Temperature:
1. Push .AKE.
2. Set the temperature to 550°F/2880C by pushing the A.
3. Within 2 seconds, push and hold ,AKEfor approximately 5 seconds until the special 2 digit display appears.
Release .A,_ The display now indicates the difference in degrees between the original factory temperature
setting and the current temperature setting. If the oven control has the original calibration, the display will
read "00".
4. The temperature can now be adjusted up or down 35°F/21°C, in 5°F or 3°C increments, by pushing the A
or V. Proceed until the desired amount of degrees adjustment appears in the display. When adjusting for a
cooler temperature, a minus sign (-) will appear before the number in the display.
5. When you have made the desired adjustment, push _
to go back to the time of day display.
27