Kenmore 790.9010 Series Use & Care Manual page 12

Control Pad Functions
Note: The appearance of your oven control may differ slightly from the one illustrated below. However, all functions are
the same.
READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. Detailed instructions for each function follow later
in this book. For satisfactory use of your oven, become familiar with the various functions of the oven as described below.
OFF/CANCEL
Used to clear
any oven mode
previously entered
except the time of
day and the minute /
timer. Push clear to
stop cooking.
BAKE
Used to enter the
normal baking mode
BROIL
Used to select
the broil m
CLEAN
Used to select the OVEN, PREHEAT
self-cleaning mode AND LOCKED
indicates which
mode is in use.
UP and DOWN ARROWS
Used to set the clock,
the timer and the oven
temperature
41D OVEN
o PREHEAT
DOOR LOCKED
CLOCK
Used to set the
time of the day.
TIMER ON/OFF
STOP TIME i
COOK TiME
Used to enter
the length of the
cooking time.
Used to set or cancel
the minute timen The
minute timer does
not start or stop
cooking.
Used with BAKE, OVEN
COOK TIME, and CLEAN to
program delayed baking or
delayed self=cleaning cycle
stop time.
Note: Push buttons or pads may be shaped differently.
Note: After the appliance is first plugged in, or after a power interruption, the clock must be set to the correct
time of day before the rest of the electronic control functions witl operate.
The oven can be programmed for:
* Conventional baking and roasting
* Conventional Timed baking and roasting with automatic on and off times.
* Vari broiling
* Self=cleaning
For a silent control panel:
When choosing a function, a beep will be heard each time a pad is pushed, if desired, the controls can be pro=
grammed for silent operation. Push and hotd STOP TIME. After 7 seconds, the control will beep once. This witl
block the controls from sounding when a pad is pushed. To return the sound, push and hold STOP TIME again for
7 seconds until a beep is heard.
Note: The controt witl return to the audible mode after a power outage.
Setting the Clock
When the range is first plugged in, or when the power supply to the range has been interrupted, the display witl
flash "12:00".
iNSTRUCTiONS PRESS DISPLAY
To Set the Clock: (example 1:30)
1. Push _.The timer allows you 5 seconds to go to step 2.
2. Push and hold the A or V to set the time of day to 1:30.
You may also push _.
Note: The time cannot be changed during any timed bake or self-clean cycle.
AorV
®
12