Kenmore 790.9010 Series Use & Care Manual page 11

Before Setting Oven Controls
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN iS COOL (PRIOR TO OPERATING THE OVEN). Always use
oven mitts when using the oven.
Oven Vent Location Removing and Replacing Oven
(Models: 790.9010 _) (Models: 790.9015 _) Racks
The oven is vented through the right
rear coil element. When the oven is on,
warm air is released through the vent.
This venting is necessary for proper air
circulation in the oven and good baking
results. DO NOT block the vent(s).
Doing so may cause cooking failures,
fire or damage to the appliance.
Oven Vent Location
II
The oven is vented at the right rear
of the cooktop. When the oven is on,
warm air is released through the vent.
This venting is necessary for proper air
circulation in the oven and good baking
results. DO NOT block the vent(s).
Doing so may cause cooking failures,
fire or damage to the appliance.
Oven Vent Location
To remove an oven rack, putt the
rack forward until it stops. Lift up
front of rack and slide out.
To replace an oven rack, fit the
rack onto the guides on the oven
walls. Tilt the front of the rack
upward and slide the rack back
into place.
Air Circulation in the Oven
if using multiple pans, stagger as shown, if using one
pan, place in center of oven.
For best air circulation and baking results, center
pans as much as possible. Allow 2-4" (5-10 cm)
around the ustensil(s) for proper air circulation and
be sure pans do not touch each other or the door,
sides and back of oven. The hot air must circulate
around pans in the oven for even heat to reach all
parts of the oven.
11