Installation; How To Install - Kenmore 580.75251 Owner's Manual

INSTALLATION
Pick a location which will allow you to blow the cold
air into the area you want. Windows used for
installation must be strong enough to support the
weight of the air conditioner. Good installation with
special attention to the proper position of the unit
wilt lessen the chance that service wilt be needed.
When cooling more than one room, installation
location is very important. To cool your rooms, cold
air must be blown from the air conditioner in a
straight path.
Lastly it is adviced to save the shpping carton for
future storage of the unit.
HOW TO INSTALL
If the air conditioner is blocked by a storm
window frame, see step 16 on page 8 before
beginning to install.
D Remove the screws which fasten the cabinet at
the back and side of the unit. Save side screws.
Discard back screws.
-_ FIG. 3
_'_ Slide the unit out of the cabinet by gripping the
base pan handle and pull forward while bracing the
cabinet.
FIG. 4
_Cut the FOAM SEAL (ITEM J) to fit the
underside of the window sash. Peel off the backing
and attach the FOAM SEAL as shown in Fig. 5.
J ............... Sash
FIG. 5
_ Insert the side curtains (ITEM A) into the upper guide
and lower guide on each side of the air conditioner cabinet.
Fasten the curtains to the unit with screws (ITEM E).
Ii LI! TEM
ITEME
Lower Guide
E FIG. 6
E_ Open the window. Mark a line on the center of the
window inner sill. Loosely attach the sill bracket (ITEM C)
to the support bracket (ITEM B) using the carriage bolt
(ITEM I) and the lock nut (ITEM D).
ITEM C_
J -h ll l lfl
t- ..................... ITEM B
L_-_ ...... ITEM D FIG. 7
D Attach the sill bracket to the window sill using the
screws (ITEM F). Carefully place the cabinet on the
window inner sill and align the center of the cabinet
front with the center line marked on the window inner
sill.
/Machinescrew(ITEM H)
Cabinet . ................... \ /and locknut (ITEM D)
trackhole ,Outer
_edge of
ITEM windowsill
Carriage bolt_ ,,
andlocknut Sillbracket FIG. 8
W Using the M-screw (ITEM H) and the lock nut
(ITEM D), attach the support bracket to the cabinet
track hole. Use the first track hole as shown. Tighten
the carriage bolt and the lock nut. Be sure the cabinet
slants downward 1/4" from level.
CAUTION: Do not drill a hole in the base pan. The unit
is designed to operate with approximately 1/2" of water
in base pan.
Lower guide
\
\
_' _ i O
Cabinet
OUTDOOR FIG. 9
-6-