Cleaning - Kenmore 116.21514 Use & Care Manual

TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu-
um cleaner, the agitator must be cleaned
every time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use Clean Acjilator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times!week)
LIGHT - every 2 months
(used 1 time!week)
IMPORTANT
Disconnect vacuum cleaner from electrical
outlet, Check and remove hair, string and
lint buiid-up frequently in the PowerMate
agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
any string or
debris located
on the agitator
or end caps.
AGITATOR ASSEMBLY
End Cap
Brush Unit End Cap -
TO REPLACE BELT
NOTE= Use replacement beJt STYLECB-3,
see part number detail in REPLACEMENT
PARTS(page 6),
1. Install new ,
belt over _r
motor drive,
then over belt
path.
tator assem- \
_"-'_ Belt
Path
bly back into
Agitator
EndCap
PowerMate,
3. Verify that end
cap is pressed
firmiy into position.
3. Line up front of cover and base, Rest
cover on front edge of base as shown.
Side Rear
Latch Latches
4, Rotate cover
back. Press cover
firmly until Side
and rear latches
snap into place.
Make sure there is no gap between the
cover and base.
5. TurnPowerMateupsidedownand
replace two (2) cover screws.
24