Advertisement
Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of
door, and release hinge pin into door.
Hinge pin
on bottom
of door
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module. Total (5) connections. Connect the two wires{(a)and(b)} from the switch wiring harness into the back of the Electronic
Ignition Module. Total (2) connections, shown A.
Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart right side panel with
the nut, shown B. Insert AA battery into ignition module, negative (-) end first. Then put on the cap, shown C.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown
as (a), (b). Do not untie the wires while attaching.
0
Nut
Wire
Advertisement
