Advertisement
Place bottom shelf upside down. Insert Bent U Pin into the caster mounting plate to lock it in place, shown A.
Spin the caster clockwise into the threads on the bottom shelf until secure. Remove the Bent U Pin and
repeat for remaining casters. Make sure the two locking casters are secured at the rear and the non-locking
casters are secured at the front. After all 4 casters are secure remove the Bent U Pin and save for future
maintenance.
Non-lock caster
Lockingcaster
Bottom shelf
!
Bent U pin
Qty.1
Bent U pin
Attach side panels to bottom shelf using
three 1/4-20xl/2" screws, 7mm lock
washers, and 7mm flat washers per panel.
IMPORTANT: Panel with large hole must
be on left side of bottom shelf.
Leftside panel
(with large hole)
Make sureside panels
are pushedas far to the
rear of bottom shelfas
possiblebeforefully
tightening screws.
1/4-20×1/2"screw
Qty.6
7ram lock washer
Qty.6
7ram flat washer
Qty.6
1/4-20×1/2"screw
7ram lock washer
7ram flat washer
Right side panel
M
_ts
13
Advertisement
