Advertisement
IT!
First, remove the two screwsand lockwashers factory attachedto the sideburnervalve bracket.Position sideburner
valvebracketbeneathsidebumer s helffasciaso thatvalvestemcomesthrough larger centerholeinfascia.Alignthe holes
on valvebracket withleftandrightholeson fascia. Secureusinglockwashers andscrewsthatwere removedfrom bracket.
Next,placesideburner b ezelovervalvestemonfront sideoffascia.Alignsmallholeson bezelwithupperandlowerholeson
fascia, makingsure "OFF"ison thetop.Attachusing two#8-32x3/8"screwsand4ram lockwashers. P resssidebumer
control knob ontovalvestem.
Note: Use left and right
holes on fascia to
attach valve bracket
ScrewsandWashers
removed from valvebracket
Valvestem
Sideburner
valve bracket
b 8-32x3/8"screw
Qty.2
0
4ramlockwasher
Qty.2
Install bezel with "OFF" a ttop.
Note:Use upperand lower
holeson fasciato attachbezel
Controlknob
#8-32x3/8" s crew
Controlknobbeze
lock washer _
D
Pull out thefour knobs from controlpanel. Inserttemperaturegauge stem into the bigger hole aboveknob bezel,shownA.
Make sure the gauge is pushedin as far as it will go, then push the gauge downwarduntil it clips intothe panel, as shown
in B/C. Re-installthe knobs.
Tem
ire gauge stem
18
Advertisement
